Table of Contents
Advertisement
8-31-7
Intercharacter Delay (0x6E)
This parameter gives the host system time to service its receiver and perform other tasks between
characters.
The delay period may be set in the range from no delay to 99 msec in 1 msec increments.
After scanning the bar code below, scan 2 numeric bar codes on page 108 to set the desired
time-out.
To change the selection or cancel an incorrect entry, scan "Cancel" bar code on page 108.
Intercharacter Delay
(Default: 0 sec.)
138
OPTICON
Software Guide
MDL-1000/2000
Advertisement
Table of Contents
