Decoding Of Upc, Ean And Jan Supplemental Data - Opticon MDL-1000 Software Manual

5-2-7.

Decoding of UPC, EAN and JAN Supplemental Data

By setting parameter values (0x10), it is feasible to control the decoding of supplemental
data as follows:
・Disable(0x00) ... values in ( ) indicates default setting values
This setting enables the decoding of UPC, EAN and JAN bar codes with or without
supplemental data. It enables the decoding of UPC, EAN and JAN bar codes with
supplemental data but the supplemental data code shall not be transmitted.
・Decode(0x01)
This setting enables the decoding of UPC, EAN and JAN bar codes with supplemental data.
It does not enable the decoding of UPC, EAN and JAN bar codes without supplemental
data.
・Auto Discriminate(0x02)
With this setting, It automatically discriminates UPC, EAN and JAN bar codes with and
without supplemental data and enables the decoding.
・Enable 378/379/978/491(0x03)
This setting enables the decoding only when those bar codes with supplemental data start
with "378", "379", ''978" or "491".
In case with UPC, EAN and JAN bar codes with other supplemental data, this setting shall
ignore those supplemental data.
・Enable 378/379(0x04)
This setting enables the decoding only when EAN-13 bar codes start with "378" or "379"
In case with UPC, EAN and JAN bar codes with other supplemental data, this setting shall
ignore those supplemental data.
・Enable 978(0x05)
This setting enables the decoding only when EAN-13 bar codes start with "978".
In case with UPC, EAN and JAN bar codes with other supplemental data, this setting shall
ignore those supplemental data.
・Enable 491(0x06)
This setting shortens JAN13 bar codes which start with "491" to 5 digits of supplemental
data. (Used for decoding of bar codes on magazines).
In case with UPC, EAN and JAN bar codes with other supplemental data, this setting shall
ignore those supplemental data.
54
OPTICON
Software Guide
MDL-1000/2000