Table of Contents
Advertisement
8-9
Scanning Time（0x88）
This parameter sets maximum time decode processing continues during a scan attempts. It is
programmable in 0.1 second increments from 0.5 to 9.9 seconds. The default setting of the time
out is 3.0 seconds.
To set scanning time, scan the bar code below and then scan 2 numeric bar codes on page 108
that correspond to the desired scanning time. If the desired value is a single digit number, it must
have a leading zero. Please scan the "0" bar code first.
For example. To set an on time of 0.5 seconds, scan the bar code below, then scan the "0" and "5"
bar codes. To change the selection or cancel and incorrect entry, scan "Cancel" bar code on page
108.
Decoding Time
（Default Setting: 3.0 Seconds）
65
OPTICON
Software Guide
MDL-1000/2000
Advertisement
Table of Contents
