Water Temp Sensor Installation - Honda Hondex HE-773-III-Di Operation Manual

WATER TEMP SENSOR INSTALLATION

Water temp sensor is optional.
Any works on the vessel are very unstable and risky.
Installation/maintenance of water temp sensor should be handled after the
vessel on ground or fixing the vessel at shipyard etc. If not, it may cause serious
injuries.
Do not operate the electronic tools with wet hands.
It causes electronic shock.
[Installation of Thru-Hull Water Temp Sensor (15m) TC02CS]
*For FRP vessel only.
Water flow
Kingston Direction
*Be sure to install the kingston with correct direction
for steady display of water temp.
[Installation of Transom Water Temp Sensor]
TC02ES
Sensor
(The use of this sensor is prohibited for aluminum vessels due to the risk of corrosion.)
Sensor
Cork
Nut
Washer
Rubber Gasket
Sailing direction
Sensor
TC02CS
Kingston for Water Temp Sensor
Put the seal for waterproof at joint point.
Sailing direction
Water Flow
TC03-05, TC03-10
79
TC03-05
TC03-10