MAIN UNIT INSTALLATION
Install the unit firmly.
If not, it may cause the human injuries.
Install the unit correctly according to the following instruction.
Procedure
<Mounting the main unit>
Using the holes (8 places) of the mounting base of the main unit, attach with the
attached screws.
Attach the main unit referring to the figure.
1. <Positioning>
Determine the mounting position with the mounting base on the main unit, and attach a
mark.
Please leave clearance enough to connect cords behind the main body.
2. <Bracket>
Using the mounting holes (8 places), use the attached screws.
* Point the cutouts at both ends of the frame toward the front side of the main unit.
3. <Main unit>
Attach the main unit referring to the figure.
Screw
5×20 SUS
Paste the circular nameplate on the
hole of the knob bolt not to be used.
Main Unit
Anti-vibration rubber for gantry
65
Washer for gantry
Knob bolt