Table of Contents
Advertisement
HP ESG and HP ESG-D Series Signal Generators
Settings conflict; FM2/PM2 value set greater than FM1/PM1
value. FM1/PM1 changed to match FM2/PM2 value.
The deviation of FM2/PM2 must always be less than or equal to the
deviation settings for FM1/PM1. This error will be reported to the queue
when FM1/PM1 is enabled and FM2/PM2 is also enabled and an
adjustment to either FM2/PM2 deviation causes the FM2 or PM2
deviation to be greater than the FM1 or PM1 deviation. It will also be
reported when FM2/PM2 is being turned on, and the last FM1/PM1
deviation setting is less than the current FM2/PM2 deviation setting. In
both cases the FM1/PM1 deviation will be adjusted to match the FM2/PM2
deviation.
Settings conflict; FM1/PM1 value set less than FM2/PM2 value.
FM2/PM2 changed to match FM1/PM1 value.
The deviation of FM2/PM2 must always be less than or equal to the
deviation settings for FM1/PM1. This error will be reported to the queue
when FM2/PM2 is enabled and FM1/PM1 is also enabled and an
adjustment to either FM1/PM1 deviation causes the FM1 or PM1
deviation to be less than the FM2 or PM2 deviation. It will also be reported
when FM1/PM1 is being turned on, and the last FM2/PM2 deviation
setting is greater than the current FM1/PM1 deviation setting. In both
cases the FM2/PM2 deviation will be adjusted to match the FM1/PM1
deviation.
Settings conflict; Enabled mod source conflicts with previously
enabled mod source. Previous mod disabled.
The signal generator has three sources: INT, EXT1, and EXT2 that are
shared by the FM1/PM1, AM1/AM2, FM2/PM2, pulse (INT and EXT2),
and burst envelope (EXT1 only). Each source can only be used by one of
the modulations at a time. If a source is being used by an active
modulation, and a request for the source is made by another modulation,
the first modulation will be turned off, the second modulation will be
turned on.
Settings conflict; External burst cannot be on while using AM.
Indicates that there is a hardware conflict for the burst envelope using the
EXT1 source (I/Q menu) and AM1/AM2. The most recently requested
modulation will be turned on, the previous modulation will be turned off.
Settings conflict; FM & PM not allowed.
Indicates that there is a hardware conflict between FM and PM. The most
recently requested modulation will be turned on, the previous modulation
will be turned off.
User's Guide
Troubleshooting
-299 to -200: Execution Errors
3-35
Advertisement
Table of Contents
