Freq - HP ESG Series User Manual

HP ESG and HP ESG-D Series Signal Generators

Freq

Pressing the front panel
softkeys are described in this section in alphabetical order.
Adjust Phase
Use this softkey to change the phase of the RF OUTPUT signal. You
can change the phase relative to whatever phase the signal generator
locked to the last time it changed frequency. For this reason, the phase
adjustment does not survive changes in frequency and must be
readjusted. If you first press
set as a zero reference and any subsequent phase adjustment is
displayed as relative to the zero reference. Phase adjustment cannot be
used with frequency or phase modulation.
To change the phase, press the softkey once. Phase adjustment becomes
the active function. To enter a new value, rotate the front panel knob
until the desired value is displayed, use the up and down arrow keys, or
enter the value using the numeric keypad and press the
terminator softkey. The range of values allowed is ±3.141 radians or
±180 degrees.
Softkey Location: Press
Status after Normal Preset: 0 radians
SCPI Commands:
User's Guide
[:SOURce]:PHASe:[ADJust] <val><unit>
[:SOURce]:PHASe:[ADJust]?
key reveals a menu of softkeys. These
Freq
, the current output phase is
Phase Ref Set
,
Freq Adjust Phase
Hardkey and Softkey Reference
Freq
or
rad deg
5-41