Configuring The System; Accessing The Menu Structure - Haes MZAOV-1001 Installation, Commissioning & Operating Manual

Multizone AOV User Manual

CONFIGURING THE SYSTEM

When the system is installed and is ready to be commissioned, configure as follows:
•
Use the CONFIG PANEL menu LEARN option, to enable the panel to automatically
learn what internal cards, external devices (detectors, sounders, etc.), and Peripheral
BUS (P-BUS) Remote Control Call Points are connected in the system.
•
Set the panel user interface controls (Time & Date, Display contrast, internal buzzer
volume, etc.), using the User menus described below.
•
Configure the system (vent zones, devices, etc.), identified by the CONFIG PANEL
menu LEARN option, using the User menu DISABLE sub-menus and CONFIG menus,
described below.
•
Any alarm or fault events, system status etc., can be viewed using the Report menus,
described below.
•
Outputs from the various vents and RSUs fitted in the system can be tested from the
ENG menu OUTPUTS option, described below.

Accessing the Menu Structure

Power on the panel and wait for it to perform a routine status check. Any faults detected will
be displayed, accompanied by a warning tone. Press the Mute Buzzer button to silence the
warning tone. Resolve any faults before proceeding.
by pressing the ✓ button, the LCD unit displays the following Access Level 2
Next proceed
Menu (see picture below):
Note: Access level 2 Menu will deactivate after 30 sec if not used.
On the LCD screen, the box surrounding the menu icon is the cursor; this can be navigated
through the menu options by using the Left/Right arrow keys to select required menu option
and then pressing the ✓ key.
The Left/Right and Up/Down arrow keys can then be used to access further sub-menus and
options within the main menus.
Press ✓ key to select required sub-menu or option and to make changes to a selected
option.
Where there are options that have adjustable values, these are altered with the Up/Down
arrow keys followed by pressing ✓ key, when required value is reached.
Use the return key to exit all menus and options.
Approved Document Ref: UI-MAOV-01 Issue 1.0
CONFIGURING THE SYSTEM
47