Baumatic B725SS Instruction Manual page 23

•
Re-fix the burner assembly ensuring that the injector is within the cut
out in the rear of the oven and adjust the position of the burner to
achieve the primary air gap (Fig. 4).
•
For primary air gap settings see table page 20.
Grill Burner
•
Pull the oven out and remove the outer casing oven.
•
Replace the injector with the one suitable for the gas to be used as listed
in the table page 20. It is recommended that the appropriate thread
sealant be used, always check for gas soundness after assembly (Fig. 5).
To Regulate Thermostat Bypass
•
Remove control panel cover from the top of the appliance.
•
Remove the oven control-knobs and undo the two fixing rings now
exposed (anti-clockwise).
•
Disconnect neon lamp at rear of fascia and remove control-panel
front, then refit thermostat control knob.
•
Ensuring that the appliance is in a safe condition, reconnect to the
electric and gas supply.
•
Open oven door fully, ignite oven burner, set to maximum
temperature, close oven door and leave for 10 – 15 minutes.
•
Reduce temperature setting to minimum and remove control knob
•
Disconnect electrical supply
•
Adjust bypass setting until correct flame picture is achieved. The
bypass adjustment screw is located on the right-hand side of the valve
body and access can be made from the front of the appliance through
the rear panel of the control-panel. Turn screw clockwise to decrease
flow (see Fig 6).
•
Refit control-knob, then increase to Max and decrease to Min setting
several times to check that the flame is maintained.
•
Open and close the oven door fully several times to ensure that the
flame is maintained.
•
Turn the appliance off and disconnect from the gas supply.
•
Re-assemble the appliance, re-install and carry out a function test
21