Electrical Requirements - Baumatic B725SS Instruction Manual

ELECTRICAL REQUIREMENTS

WARNING: THIS APPLIANCE MUST BE EARTHED.
Electrical installation must comply with all relevant local and
national regulations. Make sure that the voltage supply is the same
as the rating given on the data plate positioned on the lower part of
the front of the oven.
This appliance must be connected to an a.c. single phase 230V-
240V, 50Hz electricity supply.
The total rated load is 0,09 kW.
The oven must be connected to a 3 Amp power supply via a double
pole-isolating switch with a minimum opening between the contacts
of 3mm. The switch must be of easy access once the appliance is in
place for maintenance and service purposes.
This appliance is supplied with a connection cable.
In case of replacement of the cable please contact only qualified
personnel .
Cable type: H05RR-F 3 x 1,5
The connection clamp for the cable is at the rear of the appliance.
Unscrew and remove the cover, then insert the cable by way of the
cable clip and connect according to the drawing on page 27. the
earth wire of the power supply cable must be longer than the positive
and negative conductors. Tighten the cable clip screws and close the
cover.
Maintenance and servicing work must only be carried out after the
power supply has been disconnected, either by switching off at the
wall socket or disconnecting at the main fuse box.
Note: The actual ventilation requirements must be determined by
reference to the Statutory regulations in force.
19