Ventilation Requirements - Baumatic B725SS Instruction Manual

60 cm built-under twin cavity gas oven and grill

Hide thumbs Also See for B725SS:

Reference manual (1 page)

Brochure (330 pages)

Table Of Contents

Table of Contents

A 5-8mm ventilation gap must be allowed between the top of the

appliance and the underside of the working top.

Two systems can be used to fit your appliance to a chosen furniture

layout:

A) Between two side panels of two distinct cabinet units without the

aid of a support shelf, by fitting four support steel brackets

provided with the product. (See Sys A, fig. 1, page 15)

B) Between two side panels each fixed to the side of a cabinet unit

without the aid of a support shelf. In this case only the two lower

support brackets will be necessary. (See Sys B, fig. 2, Page 15)

Note: In both the above cases you must measure 717mm from the

underside of the worktop and mark the correct position of the lower

support brackets before fixing them to the sides. With reference to

(Sys A, fig. 1) ensure side support brackets are positioned 40mm

from the front of the cabinet door exterior surface, as illustrated,

before securing them to the cabinet sides.

NOTE:

If necessary, this product can be installed in a housing unit. The

housing unit will not be a standard one but will have to be of a size

THIS APPLIANCE IS ONLY DESIGNED TO BE INSTALLED IN A

to accept the full height of the oven – minimum height 717mm.

BUILT UNDER SITUATION AND ON THE BRACKETS SUPPLIED

Furthermore it will have to respect all the ventilation required.

IT MUST NOT BE INSTALLED IN A TALL HOUSING AT EYE LEVEL.

IMPORTANT