Cancel Man-Down And No-Movement Alarm; Delay Man-Down And No-Movement Alarm Temporarily; Reset Man-Down And/Or No-Movement Alarm; Automatic Call After Alarm - ASCOM i63 User Manual

Alarm Operation
6.2.2

Cancel Man-down and No-movement Alarm

A Man-down or No-movement detection can be cancelled before the alarm is sent out.
When the handset enters the warning phase and the message Man-down warning. Cancel? or No-
movement warning. Cancel? appears, do one of the following to cancel the alarm:
• Press OK.
• Press any key including the wired headset button
• Move the handset to an upright position (for Man-down).
6.2.3

Delay Man-down and No-movement Alarm Temporarily

You can delay Man-down or No-movement alarm before it is sent. To do this, during the warning phase
press the Mute button and then press Yes to confirm the message Delay MD/NM detection?. The
corresponding display icon flashes until the alarm is active again (default 10 min).
This feature can be enabled by the system administrator using the WinPDM/Unite DM. Please refer to the
Configuration Manual, Ascom i63 VoWiFi Handset, TD 93300EN.
6.2.4

Reset Man-down and/or No-movement Alarm

You can reset the alarm that has been triggered, by doing one of the following:
• Move the handset to an upright position (after Man-down).
• Move the handset (after No-movement).
• Press any button
22
• Press the Mute button if the ALS sounds.
The corresponding icon flashes until the alarm has been reset.
6.3

Automatic Call after Alarm

A handset can be set up to call a predefined number after an alarm has been sent, for example to "112"
which is the common emergency call number inside the European Union.
Any ongoing call will be automatically terminated prior to establishing the automatic call.
Depending on the settings, the call can be established in the following modes:
• Loudspeaking mode — the loudspeaker is turned on.
• Monitor mode — the loudspeaker is muted and the microphone is on.
• Normal mode — the call is established in an ordinary call.
For more information, refer to the Configuration Manual, Ascom i63 VoWiFi Handset, TD 93300EN.
20. Except for the bluetooth headset button.
21. Configured by the system administrator.
22. Except for the top button.
32
including the wired headset button.
.
20
21
TD 93289EN / 09 April 2020 / Ver. C
USER MANUAL
Ascom i63 VoWiFi Handset