Confer Plastics ROLLGUARD 7200 Assembly, Installation And Use Manual page 3

Helpful Hints:
1). Assemble the ladder by laying it down on a smooth flat surface.
2). All ten treads are the same, but must be installed tab marked minus [-] into tread lock opening
marked minus [-] and tab marked plus [+] into tread lock opening marked
plus [+] on the rails. TREADS MUST NOT BLOCK THE ROLLGUARD ® TRACKS LOCATED ON
THE INSIDE AND OUTSIDE RAILS.
3). The ROLLGUARD ® locking assembly is pre-installed on the left bridge.
4). Slide the ROLLGUARD ® into track, grab handle first.
STEP 1:
INSIDE LADDER
#1: Lay "IL" rail on flat surface.
#3-5: Install 3 more treads, for a total of 4, see above pictures.
#6: Lay "IR" rail on flat
surface.
Tools needed:
Parts needed:
#2: Correct, tap down
until seated, note track is
not blocked.
#7: Lift/rotate and align
tread tabs to fit into rail
openings.
rubber mallet
1- Inside left rail (marked "IL" at the top)
1- Inside right rail (marked "IR" at the top)
4- Ladder treads
Track
#8: Tap all 4 treads
down until seated.
Track
Incorrect, do not
block track.
#9: Do Not Install
bottom tread
until Step 4!
3