Advertisement
Quick Links
Dealer/Installer: Give manual to homeowner.
Installer: Read "Safe Installation" on next page and all instructions before beginning. For proper assembly
and installation, instructions must be followed completely.
Homeowner: Read "Safe Use" in #7200 ladder instructions before using. Gate must be latched at all times.
Secure gate with padlock when not in use. Save these instructions.
Installation must comply with local codes and may require permits.
#7200-G GATE INSTRUCTIONS –
FOR USE WITH #7200 LADDER
Ladder must be attached to pool frame -
not for use on soft-sided/inflatable pools.
ASSEMBLY, INSTALLATION AND USE MANUAL
Assembly video available online: www.conferplastics.com
Scan to
see our
Installation
Videos
To reduce the risk of drowning, entrapment, falls, paralysis, electrocution, or
other serious injury or death:
Made in the U.S.A. by
Advertisement
Related Manuals for Confer Plastics 7200-G
Summary of Contents for Confer Plastics 7200-G
- Page 1 Homeowner: Read "Safe Use" in #7200 ladder instructions before using. Gate must be latched at all times. Secure gate with padlock when not in use. Save these instructions. Installation must comply with local codes and may require permits. #7200-G GATE INSTRUCTIONS – FOR USE WITH #7200 LADDER Ladder must be attached to pool frame - not for use on soft-sided/inflatable pools.
- Page 2 Model #7200-G Gate for 7200 Ladder 7200 LADDER MUST BE ASSEMBLED AND ATTACHED TO POOL BEFORE GATE IS ATTACHED. SLIDE ROLL-GUARD TO INSIDE If missing parts call - Toll free U.S./Canada - 800-635-3213 or www.conferplastics.com PARTS: 1-GATE 5- 1/4-20 X 2- 1/4” BOLTS...
- Page 3 Slide the bottom hinge bracket up on to the bolts Place washer over each bolt and start the 1/4-20 and tighten securely. hex nut Place the gate on edge and carefully install latch Slide the top hinge bracket on to the bolts as using a rubber mallet.
- Page 4 With the gate closed, position the latch plate so the latch rides over the lower edge of opening and drops down and hooks. Try opening/closing gate several times while holding latch plate in place. Reposition if nec- essary. Gate MUST latch when closed. Center the screw hole in latch plate over the mold line on ladder rail, mark position hole and drill through one side only of ladder handrail using 5/16”...
- Page 5 FIRST INSTALL THE 7200 GATE AS PER THE INSTRUCTIONS. 1. DRILL A I/8” PILOT HOLE IN THE TOP RIGHT HAND CORNER OF THE SECOND TREAD. SEE FIGURE 1. 1/4“ 2. PLACE A WASHER OVER THE #10 X 1-1/4” SCREW AND INSERT THROUGH THE OPEN LOOP AT THE END OF THE TENSION BAND.
- Page 6 CONFER PLASTICS INC. FIVE YEAR WARRANTY Confer Plastics Inc. warrants their swimming pool ladders and spa products to be free from defects in workmanship for five years from date of purchase. DO NOT RETURN DEFECTIVE PART TO DEALER E-MAIL CONFER PLASTICS AT: LADDERS@CONFERPLASTICS.COM A PICTURE [S] OF DEFECTIVE PART, A BRIEF DESCRIPTION OF PROBLEM, PROOF OF PURCHASE AND YOUR CONTACT INFORMATION.