C Using Commands To Enable Vpt300 Tracking In Idle State - Huawei VPT300 Installation And Commissioning Manual

VPT300 Intelligent Camera
Installation and Commissioning Guide（Single-
VPT300）
C
Step 1 Enable Telnet or SSH login.
1.
2.
3.
4.
Step 2 Log in to the TE endpoint using Telnet or SSH.
Step 3 Enter the user name debug and press Enter.
Step 4 Enter the password (Change_Me by default) and press Enter. The command-line
interface is displayed.
Step 5 Enter ui config set common.VptCamAllowCtrl and press Enter.
Step 6 Enter 1 and press Enter.
Step 7 Enter ui config save and press Enter.
Issue 04 (2020-02-11)
Using Commands to Enable VPT300
Log in to the web interface of the TE endpoint. For details, see
to the Web Interface of an
Choose System Settings > Security.
In the SSH/Telnet area, set Telnet login or SSH to Allow, as shown in
C-1.
Figure C-1 Enabling Telnet or SSH login
Click Save.
Copyright © Huawei Technologies Co., Ltd.
C Using Commands to Enable VPT300 Tracking in
Tracking in Idle State
Endpoint.
Idle State
3 Logging In
Figure
41