Table of Contents
Advertisement
VPT300 Intelligent Camera
Installation and Commissioning Guide（Single-
VPT300）
2.
3.
4.
5.
6.
Step 2 Run the mnt calibswitch set 1 command.
Step 3 After the camera returns to its initial position, observe the camera image. When a
white box appears, show a face in the white box, as shown in
Figure A-2 White box appears
Step 4 Face the camera lens and do not move until the white box turns green, as shown
in
Figure
Issue 04 (2020-02-11)
In Host Name (or IP address), enter the IP address of the VPT300, for
example, 192.168.1.100. Use the default value for Port.
Set Connection type to SSH.
Click Open. The SSH login window is displayed.
If SSH login is used for the first time, the PuTTY Security Alert dialog box will be
displayed. Click Yes to access the SSH login window.
Enter the user name admin and press Enter.
Enter the password (Change_Me by default) and press Enter. The command-
line interface is displayed.
– If you forget the login password, press and hold the RESET button on the VPT300
for 10s when the VPT300 is running to factory reset it. After the factory reset, all
the settings are restored to the default settings.
– You are advised to change the password immediately at the first login. Then
change the password periodically and keep it secure.
A-3.
Copyright © Huawei Technologies Co., Ltd.
A Calibrating the Camera
Figure
A-2.
30
Advertisement
Table of Contents
