Technical Data - Stanley SDH700 Original Instructions Manual

efficient and reliable power tool service. For more information
about our authorized service centers and if you need technical
advice, repair, or genuine factory replacement parts, contact
the STANLEY location nearest you.

TECHNICAL DATA

IMPACT DRILL
Input voltage
Frequency
Power input
No-load speed
Impact rate
Chuck capacity
Max.drilling capacity
Wood/Steel/Masonary
Weight
SDH700/SDH700C
Level of sound pressure according to EN 60745:
Sound pressure (L )
pA
Sound pressure uncertainty (K
Sound power (L )
WA
Sound power uncertainty (K
Vibration emission value ah:
(ah), =
ID
(ah), =
D
Uncertainty (K) =
SDH700/
SDH700C
V 220-240
AC
H
z
W
min
-1
ipm
mm
mm 30/13/13
kg
dB(A)
) dB(A)
pA
dB(A)
) dB(A)
WA
m/s
2
m/s
2
m/s
2
VIBRATION
The declared vibration emission values stated in the technical
data and the declaration of conformity have been measured in
accordance with a standard test method provided by EN 60745
and may be used for comparing one tool with another. The
declared vibration emission value may also be used in a
preliminary assessment of exposure.
WARNING! The vibration emission value during
actual use of the power tool can differ from the
declared value depending on the ways in which the
50-60
tool is used. The vibration level may increase above
the level stated.
700
When assessing vibration exposure to determine safety
0-2900
measures required by 2002/44/EC to protect persons regularly
49300
using power tools in employment, an estimation of vibration
exposure should consider, the actual conditions of use and the
1.5-13
way the tool is used, including taking account of all parts of the
operating cycle such as the times when the tool is switched off
and when it is running idle in addition to the trigger time.
1.87
100
3
110
STANLEY declares that these products described under
3
"technical data" are in compliance with: 2006/42/EC, EN
60745-1:2009 + A11:2010, EN 60745-2-1:2010
These products also comply with Directive 2014/30/EU and
2011/65/EU. For more information, please contact STANLEY
8.7
at the following address or refer to the back of the manual.
3.8
The undersigned is responsible for compilation of the
1.5
technical file and makes this declaration on behalf of
STANLEY.
(Original instructions)
EC declaration of conformity
MACHINERY DIRECTIVE
SDH700, SDH700C - Impact Drill
STANLEY , Europe, Egide Walschaertsstraat14-18,
ENGLISH
Ed Higgins
Engineering Manager
2800 Mechelen, Belgium
05.2020
7