Table of Contents
Advertisement
Follow These Steps To Move A Disabled Vehicle:
1. Press the Engine START / STOP Button
until RUN has been selected.
2. Press Brake Pedal and Turn OFF the Electric
Park Brake (EPB) if it was engaged.
3. Press the Brake Pedal & Shift out of Park.
4. Release Brake Pedal - vehicle should now
be free to roll. Make sure to maintain
control of the vehicle while the EPB is not
applied and the vehicle is not in Park.
5. After moving vehicle, shift transmission
back into Park. Apply EPB as appropriate.
IN CASE OF EMERGENCY
NOTE:
If the vehicle's 12 Volt Battery has been suffi-
ciently discharged that it cannot provide
sufficient power to allow shifting out of Park
or disengaging the EPB, a 12 Volt DC jump
pack can be connected to the under vehicle
jump posts. However, if connection is lost to
this auxiliary power source, or the auxiliary
source becomes discharged, the vehicle may
attempt to secure itself by shifting back into
Park.
If the vehicle is being pushed, it should not be
pushed more than 1 mile, and the pushing
speed should not exceed 10 mph.
71
6
Hide quick links:
Advertisement
Table of Contents
