Lenovo motorola Moto G Service And Repair Manual page 72

Moto G (4th Generation)
Level 2 – Service and Repair Manual
24. Place Kapton Tape over the screw near the
SIM Trays. Align the tape with the wall of the
Battery pocket.
25. Apply rolling pressure to connect the Display
Flex BtB Connector to the PCB.
26. Remove the Display Flex BtB Copper Tape
from the carrier.
27. Place the Copper Tape across the Display
Flex BtB Connector, over the Shields as
shown. Align the long edge of the tape to the
long edge of the Battery pocket.
28. Press down on the Copper Tape for 5
seconds to secure the Copper Tape to the
Display Flex BtB Connector and Shields.
29. Apply rolling pressure to connect the
Fingerprint Sensor Flex BtB Connector to the
PCB.
NOTE
The Fingerprint Sensor is only available on the
16 MP model.
PAGE 72
Motorola Mobility Confidential Restricted:
Do not share without consent from Motorola