Table of Contents
Advertisement
Moto G (4th Generation)
Level 2 – Service and Repair Manual
7.
Remove the Speaker Mesh from the carrier.
8.
Place the Speaker Mesh on the top of the
Front Housing, aligning it with the etched
recess.
9.
Press down on the Speaker Mesh for 5
seconds to secure it to the Front Housing.
10. Remove the Fingerprint Sensor Spacer from
the carrier.
NOTE
The Fingerprint Sensor Spacer is only needed
for the 13 MP model.
11. Place the Fingerprint Sensor on the bottom of
the Front Housing, aligning it with the etched
recess.
12. Press down on the Fingerprint Sensor Spacer
for 5 seconds to secure it to the Front
Housing.
13. Remove the Kapton Tape from the carrier.
14. Place the Kapton Tape on the Front Housing.
Align it to the edge of the Housing, and align
the hole in the upper right corner of the liner
with the hole in the Housing.
15. Remove three Kapton Tape circles from the
carrier.
16. Place the Kapton Tape circles over the three
screw holes in the Front Housing as shown.
PAGE 113
Motorola Mobility Confidential Restricted:
Do not share without consent from Motorola
Advertisement
Table of Contents
