Table of Contents
Advertisement
Moto G (4th Generation)
Level 2 – Service and Repair Manual
5.
Use the Torque Driver and 3IP Torx Bit to
remove the 2 3IP Machine Screws from the
PCB.
NOTE
After you remove the 3IP Machine
Screws, you cannot reuse them.
6.
Lift the bottom of the PCB away from the
Front Housing at an angle to disengage the
snap at the top of the PCB.
7.
Remove the PCB from the Front Housing.
// CAUTION //
Verify you did not damage the Display Flex or
Fingerprint Sensor Flex while lifting the PCB.
NOTE
After you remove the PCB, replace the
Loudspeaker Pads. For more information, see
Loudspeaker Pad Removal on page 41.
PAGE 36
Motorola Mobility Confidential Restricted:
Do not share without consent from Motorola
Advertisement
Table of Contents
