Table of Contents
Advertisement
Moto G (4th Generation)
Level 2 – Service and Repair Manual
Lens Removal Fixture Setup
1.
Verify that the Vacuum O-ring (4-00-A2-
10000) is positioned in the Generic Lens
Removal Fixture
(4-00-X2-10000/4-00-X7-10000) as shown.
NOTE
The Generic Lens Removal Fixture vacuum will
not perform correctly if the Vacuum O-ring is
not in position.
2.
Place the Affinity Main Lens Removal Fixture
(3-00-G2-11000) into the Generic Lens
Removal Fixture.
3.
Press the black power switch (not shown) on
the back of the Generic Lens Removal Fixture
to turn the fixture ON.
4.
Turn the vacuum knob (circled) clockwise until
it stops.
5.
Wait 5-10 minutes for the Generic Lens
Removal Fixture to warm up to 85 °C (185
°F).
// CAUTION //
Damage to the assembly may occur if the
Generic Lens Removal Fixture is not warmed
up to operating temperature before use.
NOTE
If the controller on the Generic Lens Removal
Fixture must be adjusted, see the user manual on
page 109.
PAGE 101
Motorola Mobility Confidential Restricted:
Do not share without consent from Motorola
Advertisement
Table of Contents
