Table of Contents
Advertisement
Moto G (4th Generation)
Level 2 – Service and Repair Manual
3.
Slide the Thin Plastic Spudger into the gap
between the Display and the Housing.
4.
Move the Thin Plastic Spudger around the
edge of the Display to free the adhesive.
// CAUTION //
Do not insert the Thin Plastic Spudger deeper
than 1 mm. Deeper insertion may separate the
Display and Lens and cause damage.
NOTE
While moving the Thin Plastic Spudger around
the Display, insert a shim or Thin Plastic
Spudger between the separated edges to
prevent the Display from re-adhering to the
Housing.
5.
When the adhesive has been freed, slightly lift
the Display from the Housing.
// CAUTION //
To avoid damage to the Ground Flex tabs,
Display Flex, or the Fingerprint Sensor Flex, do
not lift the Display any higher than necessary to
disconnect these flexes.
6.
Verify that no other connection exists between
the Display and the Front Housing assembly.
7.
Lift the Display out of the Front Housing,
guiding all flexes through the slots in the Front
Housing.
// CAUTION //
Do not damage the Ground Flex tabs, Display
Flex, or the Fingerprint Sensor Flex.
PAGE 108
Motorola Mobility Confidential Restricted:
Do not share without consent from Motorola
Advertisement
Table of Contents
