Replacing The System Backplane In The 8335-Gca Or 8335-Gta - IBM S822LC Servicing

Figure 65. Lifting out the backplane
13. Place the system backplane on the ESD mat.

Replacing the system backplane in the 8335-GCA or 8335-GTA

To replace the system backplane, complete the steps in this procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap attached. If not, attach it now.
2. Remove the replacement system backplane from the static-protective package and place it on an ESD
mat.
3. Using the blue lift points, lower the system backplane (A) into the system, sliding it to the back of
the system. Ensure that the connectors align and pass through the rear of the system.
Removing and replacing parts
65