IBM S822LC Servicing page 51

Figure 35. Replacing memory DIMM in a slot on the riser
b. Grasp the memory DIMM along its edges and align it with the slot on the riser.
Attention: Memory is keyed to prevent it from being installed incorrectly. Note the location of
the key tab within the memory connector before you attempt to install it.
c. Press firmly on each side of the memory DIMM until the locking tab locks in place with an
audible click.
7. To replace the memory riser, complete the following steps:
a. Ensure the release latches are open to about a 60 degree angle, as shown in Figure 36 on page 36.
b. Align the memory riser with the connector.
c. Press the memory riser firmly into the connector.
d. Press the release latches into the closed position. See (A) in Figure 36 on page 36.
Removing and replacing parts
35