Preparing The System For Operation After Removing And Replacing Internal Parts For The 8335-Gca Or 8335-Gta - IBM S822LC Servicing

CAUTION: Do not place any object on top of a rack-mounted device unless that rack-mounted
device is intended for use as a shelf. (R008)
(L012)
CAUTION: Pinch hazard. (L012)
11. Remove the service access cover. For instructions, see "Removing the service access cover from an
8335-GCA or 8335-GTA system" on page 109.
Preparing the system for operation after removing and replacing
internal parts for the 8335-GCA or 8335-GTA
To prepare the IBM Power System S822LC (8335-GCA and 8335-GTA) system for operation after
removing and replacing internal parts, complete the steps in this procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap attached. If not, attach it now.
2. Replace the service access cover. For instructions, see "Installing the service access cover on an
8335-GCA or 8335-GTA system" on page 109.
3. Place the system into the operating position. For instructions, see "Placing an 8335-GCA or 8335-GTA
system into the operating position" on page 112.
(L012)
CAUTION: Pinch hazard. (L012)
4. Install both of the power supplies into the system. For instructions, see "Replacing a power supply
in the 8335-GCA or 8335-GTA" on page 53.
5. Reconnect the power cords to the system. For instructions, see "Connecting the power cords to an
8335-GCA or 8335-GTA system" on page 115.
6. If applicable, close the rack door at the rear of the system.
7. Start the system. For instructions, see "Starting the system" on page 108.
8. Replace the front cover. For instructions, see "Installing the front cover on an 8335-GCA or 8335-GTA
system" on page 111.
9. If applicable, close the rack front door.
or
or
Removing and replacing parts
107