Removing And Replacing The Front Usb Cable And Connector In The 8335-Gca Or 8335-Gta; Removing The Front Usb Cable And Connector From The 8335-Gca Or 8335-Gta System - IBM S822LC Servicing

Removing and replacing the front USB cable and connector in the
8335-GCA or 8335-GTA
Learn how to remove and replace the front USB cable and connector in the IBM Power System S822LC
(8335-GCA and 8335-GTA) system.
Removing the front USB cable and connector from the 8335-GCA or
8335-GTA system
Follow these steps to remove the front USB cable and connector from the IBM Power System S822LC
(8335-GCA and 8335-GTA) system.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap attached. If not, attach it now.
2. Remove the disk drive fan card. For instructions, see ."Removing the disk drive and fan card from
the 8335-GCA or 8335-GTA" on page 9
3. Locate the front USB cable (A) and the power switch cable (B). They connect between the system
backplane and the power switch along the inside of the system. Label each cable.
Figure 18. Location of the connectors for the front USB cable and connector and the power switch cable
4. Release each cable from the retaining clip on the inside wall of the system.
5. Pressing the latch release on the connector, disconnect the front USB cable (A). See Figure 19 on page
25.
Note: The latch release on the connector must be depressed before unplugging the cable. Failure to
do so could damage the cable and the connector.
24
Servicing the IBM Power System S822LC (8335-GCA or 8335-GTA)