Removing And Replacing A Fan In The 8335-Gca Or 8335-Gta; Preparing The System To Remove And Replace A System Fan - IBM S822LC Servicing

Figure 9. Replacing the disk and fan signal cable in the system backplane and the disk drive and fan card
3. Secure the cable in the retaining clip on the inside wall of the system.

Removing and replacing a fan in the 8335-GCA or 8335-GTA

Find information about removing and replacing fans in the IBM Power System S822LC (8335-GCA and
8335-GTA) system.

Preparing the system to remove and replace a system fan

To prepare the system to remove and replace a system fan, complete the steps in this procedure.
About this task
Procedure
1. Complete the prerequisite tasks. For instructions, see "Before you begin" on page 100.
2. Identify the part and the system that you will be working on. For instructions, see "Identifying the
system that contains the part to replace" on page 103.
3. If applicable, open the rack front door.
4. Attach the electrostatic discharge (ESD) wrist strap.
15
Removing and replacing parts