HIKVISION DS-8104AHQLI-K4 Quick Start Manual page 26

Step 2 Configure the following settings.
 Language: The default language is English.
 Output Standard: Select the output standard to be PAL or NTSC.
 VGA/HDMI Resolution: Select the output resolution, which must be the same with the
resolution of the VGA/HDMI display.
 HDMI and VGA share simultaneous output. The LCD does not share simultaneous output
with HDMI/VGA output. The LCD resolution stays as 1024 × 600.
 The default VGA/HDMI resolution is 1024 × 768/60Hz. If you connect the external display to
the DVR via the HDMI or VGA interface, set the VGA/HDMI resolution lower than or equal
to 1080p, and click Apply, the attention box will pop up as shown below. Click OK within 15
seconds to change the output resolution. Or click Cancel within 15 seconds to cancel the
settings. Or wait until 15 seconds end and the resolution will restore to defaulted
1024×768/60Hz.
 If you select the HDMI resolution to 2K (2560 × 1440)/60Hz or 4K (3840 × 2160)/30Hz, and
click Apply, the VGA output will be disabled.
 Time Zone: Select the time zone.
 Date Format: Select the date format.
ATM Digital Video Recorder Quick Start Guide
Figure 3-18 General Settings Interface
Figure 3-19 Change the Output Resolution
25