Installation - Whirlpool 7LIECK-W-WL User Manual

INSTALLATION

1. Put the dispenser upright.
2. Place the dispenser on a hard and level surface in a cool
shaded location near a grounded wall outlet.
Notice: Do NOT plug in the power cord yet.
3. Position the dispenser so that the back is at least 4 inches
from the wall and there are at least 4 inches of clearance on
both sides.
4. Install the Wall Mount Strap to prevent accidental tip over:
• Unclip the strap from the back of dispenser.
• Mount the strap 25 inches up from the floor directly to
the wall stud with a screw (see Illustration A).
If the stud is not available, insert and turn the anchor
directly into the sheet rock using a Philips screwdriver
(DO NOT drill a hole into the sheet rock first when using
this anchor). Secure the strap by installing a screw
through the washer, then the eyelet into the strap, and
into the wall mounted anchor (see Illustration B).
• Position the cooler in place.
• Clip the strap onto the back of the cooler to either the
right or left side (see Illustration C).
• Adjust the length of the strap so that the dispenser
CANNOT move forward.
Note: The dispenser can be positioned in a corner
but it still requires the Wall Mount Strap to be
installed. Lengthen the strap so that once installed,
the dispenser cannot move forward.
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 1-855-5WHIRL5 for assistance.
Model # 7LIECK-W-WL: Page 8