Whirlpool 7LIECK-W-WL User Manual page 11

Initial Rinsing of Water Lines
This unit has been tested and sanitized prior to packing and shipping. During transit, dust and odors
can accumulate in the tank and lines. You must dispense and dispose at least one quart of water prior
to drinking any water dispensed from this unit.
Dispensing Cold Water
Note: After setup, it will take 1.5 hours to get the water to its maximum cold temperature. During this
time, the compressor will run continuously. This is normal.
1. Position the bottle, glass, pitcher, or cooking pot securely below the cold water tap.
- The circular shapes in the drip plate help align the flow of water. This unit dispenses water at a
fast rate. To avoid splashes, hold the cup as close to the tap as possible.
2. Press the cold water control downward to start dispensing water.
3. Release the cold water control once the desired fill level is achieved
Replacing an Empty Bottle
Notice: Replace the bottle as soon as you notice that it is empty.
1. Lift the bottle straight up to disengage it from the bottle probe.
Excessive Weight Hazard
Ask two or more people to move and install the
water cooler and the bottles.
Failure to do so can result in back or other injury.
2. Remove the tamper seal from the top of bottle cap of the fresh bottle. Do NOT remove the plastic
cap.
3. Lift the bottle and insert it onto the probe. Apply slight pressure until the plug inside the cap
pushes in and the bottle is seated. Water will begin to flow into the reservoirs, causing air bubbles
in the bottle
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 1-855-5WHIRL5 for assistance.
WARNING
Model # 7LIECK-W-WL: Page 11