Table of Contents
Advertisement
30
Packing the Sample Gas Feed Unit
Pack the Sample Gas Feed Unit
1
If the original packing material is no longer available, wrap the device in
bubble foil or corrugated cardboard. When shipping overseas, also heat-seal
the device air-tight in 0.2 mm thick polyethylene, including a desiccant (e.g.
silica gel). The amount of desiccant used should be adequate for the package
volume and the probable shipping time (at least 3 months).
2
Pack the device in an adequately large box lined with shock absorbent
material (e.g. foam material). The thickness of the cushioning material
should be adequate for the weight of the device and the mode of shipping.
The box should also be lined with a double layer of bitumen paper for
overseas shipping.
3
Mark the box "Fragile! Handle with care!".
Ambient temperature during storage and transport: –25 to +60 °C.
ATTENTION
Before the sample gas feed unit is returned to the service department, e.g. for
repair, it must be cleaned from any contamination with aggressive or
poisonous media. It has to be stated which media have been fed with the
sample gas feed unit. This information is needed so that service personnel can
take any requisite safety precautions for harmful gases.
Advertisement
Table of Contents
