lavina LB36G-S User Manual page 15

Superabrasive
THE CONTROL BOARD
Figure 4.5
6 Water pump switch Lights orange when the water pump is running.
THE CONTROL BOARD WITH DIGITAL FUEL CONTROL SYSTEM
Owner's Manual – LAVINA® LB36G-S
1 Start/Stop Engine switch Turn key fully to
the right (make contact) to start the engine,
fully to the left to stop the engine
2 Start/Stop clutch Start will electronically
activate the grinding plates to spin; stop will
disconnect engine from grinding heads
3 Throttle Push forward to accelerate.
4 Digital RPM/workings hours indicator
When the motor runs it indicates the
revolutions per minute of the
motor, see the conversion table to know the
rpm of the tools. When the motor does not
run, it indicates the worked hours.
The hour meter will blink between 48-52
hours as a reminder for oil change.
5 Fuse 30 Amp fuse for the electrical
system.
1 Start/Stop clutch Start will electronically activate the grinding plates
to spin; stop will disconnect engine from grinding heads
Complete Monitor Assembly is a high-performance digital fuel
2
control system.
3 Start/Stop Engine switch Turn key fully to the right (make contact) to
start the engine, fully to the left to stop the engine
4 Throttle Push forward to accelerate.
5 Fuse 30 Amp fuse for the electrical system.
6 Water pump switch
running.
15
5/2018
Rpm engine
2000
2100
2200
2300
2400
2500
2600
2700
2800
2900
3000
3100
3200
3300
3400
3500
3600
Lights orange when the water pump is
rpm tools
1630
1715
1796
1878
1959
2040
2120
2200
2285
2367
2450
2530
2612
2694
2775
2857
2940