Table of Contents
Advertisement
Superabrasive
Owner's Manual – LAVINA® LB36G-S
5/2018
4. OPERATION
PRELIMINARY CONTROLS
Inspect the working area as explained in the safety instructions. For wet use, fill in the water tank and check that the tool is
mounted according the instructions. Ensure the vacuum bag is placed correctly and has been emptied.
Make sure the bonnet air filter on top of the engine is clean. It should be cleaned hourly.
Check the engine oil level - screw the dipstick in to get reading. Make sure the tank is full (see also "Storage Propane tanks).
TANK and FUEL LINES – Check that any connections are not damaged or showing signs of wear, such as cracks or any
corrosion. Screw the brass fuel line fitting onto the tank service-valve and hand tighten only. This connection MUST be secure
because the service valve has a safety valve inside it, which will only open if the brass fuel-line fitting is COMPLETELY fitted
into the service valve.
WATER FLOW CONTROL UNIT
Figure 4.1
The operator may turn on the front water sprayer (Fig.4.1) by pressing the "PUMP"button on the control board.
MOUNTING TOOLS
After choosing the proper tool (Fig.4.2), make sure that there is enough diamond bond material left. Put the tool on the tool
holder in a coaxial position (Fig.4.3) and screw the tension nut (Fig.4.4).
Figure 4.2
Figure 4.3
Figure 4.4
14
Advertisement
Table of Contents
