Kinetico SuperSoft Installation Instructions And User Manual page 22

Return to contents
To manually regenerate your system, using a Phillips head
screwdriver, push down on the actuator and slowly turn
CLOCKWISE until the actuator has advanced the indicator dot
to the "BRINE" position, see Figure 4 (page 11). You should
hear at least 5 "clicks" while turning the actuator before the
indicator dot reaches the "BRINE" position. At this point
you will hear water flowing to the drain. This indicates that
you have successfully initiated a regeneration. Repeat the
procedure for manual regeneration after the water flow stops
(approximately 11 minutes) to be sure both resin tanks are
regenerated.
NOTE:
If you do not hear a flow of water running to drain, please contact
your local stockist.
NOTE:
If your hot water tank or loft storage tank has filled with hard water, it
may take several days for it to empty completely and for your water to
feel soft again.
IMPORTANT: Never turn the actuator anti-clockwise.
Cold weather protection:
3
If your SuperSoft is installed outside or in an area that is not
heated, you may want to take precautionary measures to
prevent damage to your unit from freezing. Kinetico offer
cabinets specifically designed to protect your softener from
freezing temperatures. Please call your local dealer for more
information.
NOTE:
The warranty does not cover damage caused to your system due to
freezing. If you have any questions about your SuperSoft, or
you suspect that your system isn't working properly, contact
your local stockist.
Visit: kinetico.co.uk Supersoft Water Softener 22
Installation Instructions and User Manual