Startup Instructions - Kinetico SuperSoft Installation Instructions And User Manual

Startup instructions

Initiate a backwash:
1
a:
Using a Phillips head screwdriver push down on the actuator,
and slowly turn CLOCKWISE until the indicator dot reaches
the letter W in the word "BACKWASH" on the clear cap.
b: You will hear a rush of water and air going to the drain.
c:
When the cycle has finished (approx 4 mins), repeat the
procedure, turn the indicator dot to the next backwash cycle
and allow to finish (approx 4 mins).
Actuator
Indicator
NOTE:
After the unit is pressurized, open the outlet valve, ensure isolation valve
is closed. Open a tap in the house to release trapped air from the lines.
Visit: kinetico.co.uk
Return to contents
Supersoft Water Softener
Installation Instructions and User Manual
17