Powering On Procedures For Powerstore Cluster; Power On A Powerstore T Model Cluster - Dell PowerStore 500T Installation And Service Manual

Powering on procedures for PowerStore cluster

This section includes the following procedures:
●

Power on a PowerStore T model cluster

Power on a PowerStore T model cluster
About this task
Use the following procedure to power on a PowerStore T model cluster:
Steps
1. If nodes were removed, reseat the nodes into the relevant base enclosure chassis.
2. If applicable, for each appliance in the cluster, ensure that expansion enclosures are also reseated into the cabinet.
3. For each appliance, reconnect the power cables to node A first, and then node B.
The Node Power LED on each node turns on when the power cable is connected.
62 Power control procedures
on page 62