Advertisement
NOTE:
Your computer's Service Tag is stored in the system board. You must enter the Service Tag in the BIOS setup
program after you replace the system board.
NOTE:
Replacing the system board removes any changes that you have made to the BIOS using the BIOS setup
program. You must make the appropriate changes again after you replace the system board.
NOTE:
Before disconnecting the cables from the system board, note the location of the connectors so that you can
reconnect the cables correctly after you replace the system board.
2. Remove the
side
cover.
3. Remove the
front
bezel.
4. Remove the
wireless
card.
5. Remove the
3.5-inch hard
6. Remove the
memory
module.
7. Remove the
M2 2230 SSD
8. Remove the
graphics
9. Remove the
coin-cell
10. Remove the
fan and heat-sink
11. Remove the processor.
About this task
The following images indicate the location of the system board and provides a visual representation of the removal procedure.
drive.
/
M2.2280 SSD
card.
battery.
assembly.
Disassembly and reassembly
43
Advertisement
