Table of Contents
Advertisement
Speakerphone Volume
Headset Ring Volume
Headset Volume
Speakerphone Ring Volume
G.723.1 Bit Rate
DTMF Payload Type
AMR Payload Type
Headset Mic Gain
Opus playload type
OPUS Sample Rate
ILBC Payload Type
ILBC Payload Length
Enable MWI Tone
Enable VAD
Onhook Time
EHS Type
RTP Control Protocol (RTCP) Settings
CNAME user
CNAME host
RTP Settings
RTP keep alive
Alert Info Ring Settings
Value
Ring Type
is set for the phone number, the default ringtone
will be used.
Set the hands-free volume to 1-9.
Set the volume of the earphone ringtone to 1~9.
Set the volume of the headset to 1~9.
Set the volume of hands-free ringtone to 1~9.
5.3kb/s or 6.3kb/s is available.
Enter the DTMF payload type, the value must be
96~127.
Set AMR load type, range 96~127.
Set the earphone's radio volume gain to fit
different models of earphones.
Set Opus load type, range 96~127.
Set Opus sampling rate, including opus-nb (8KHz)
and opus-wb (16KHz).
Set the ILBC Payload Type, the value must be
96~127.
Set the ILBC Payload Length
When there is a new voice message message, the
phone will start a special dial tone.
Whether voice activity detection is enabled.
Configure a minimum response time, which
defaults to 200ms
EHS headset is available after enabling.
Set CNAME user
Set CNAME host
Hold the call and send the packet after 30s
Set the value to specify the ring type.
Type1-Type9
49
Advertisement
Table of Contents
