Table of Contents
Advertisement
Add dialing rules:
Parameters
Dial rule
Note: Two different special characters are used.
◼
x -- Matches any single digit that is dialed.
◼
[ ] -- Specifies a range of numbers to be matched. It may be a range, a list of ranges separated
by commas, or a list of digits.
Destination
Port
Alias
Note: There are four types of aliases.
◼
all: xxx – xxx will replace the phone number.
Picture 20 - Custom setting of dial - up rules
Table 9 - Dial - up rule configuration table
42
Description
There are two types of matching: Full Matching
or Prefix Matching. In Full matching, the entire
phone number is entered and then mapped per
the Dial Peer rules.
In prefix matching, only part of the number is
entered followed by T. The mapping with then
take place whenever these digits are dialed.
Prefix mode supports a maximum of 30 digits.
Set Destination address. This is for IP direct.
Set the Signal port, and the default is 5060 for
SIP.
Set the Alias. This is the text to be added,
replaced or deleted. It is an optional item.
Advertisement
Table of Contents
