Top Panel Block, Bottom Panel Block - Sony HT-MT500 Service Manual

2-4.

TOP PANEL BLOCK, BOTTOM PANEL BLOCK

Note: Lay a soft piece of cloth under the unit
to avoid damaging the top panel.
2 Lift up the top cabinet block
in the direction of the arrow
at about a 90-degree angle.
top side
right side
rear side
BAR-AMP
board
wiring stopper
Press.
groove
rear side
4 Remove the speaker
connection cable from
the wiring stopper.
5 Draw the speaker
connection cable
out of groove.
7 speaker connection cable
connector (CN6010)
8 speaker connection cable
connector (CN6011)
6 Draw the speaker connection
cable out of slot.
4 Remove the speaker connection
left side
top side
top panel block
3 FFC 22P
(CN707)
9 Open the top panel
cable from the wiring stopper.
1 eight screws
(BVTP3 10)
front side
top panel
CN707
BAR-AMP
board
rear side
left side
Cable is flush with
block in the direction
the top.
of the arrow.
qa bottom panel block
5 Draw the speaker
connection cable
out of groove.
HT-MT500/MT501
1 eight screws
(BVTP3 10)
right side
MB-1610 board
terminal side
DISPLAY
board
FFC 22P
OK NG
Cable is lowered
past the top.
0 top panel block
BAR-AMP board
Press.
groove
wiring
rear side
stopper
11