Language; Factory Settings - Nordmende Transita 30 User Manual

> Use the Tune/Select knob to select the following options:
[Operation] regulates brightness in the normal operating status. You can choose from
[High], [Medium] and [Low] brightness intensities. Use the Tune/Select knob to select a
brightness level and press the Tune/Select knob to save the setting. The setting applies to
both mains power operation as well as battery operation.
[Standby] regulates the brightness in standby mode (only relevant if the radio is connected
to the mains). You can choose from [High], [Medium] and [Low] brightness intensities. Use
the Tune/Select knob to select a brightness level and press the Tune/Select knob to save
the setting.
[Auto Dim] dims the display automatically (with the option [On] selected) to the Low
brightness value after 10 seconds of not operating the radio. When the [Off] option is
selected, the display will be permanently lit at the brightness selected under [Operation].
Press the Tune/Select knob to accept a setting.
For battery operation only the settings Operation and Auto dim are relevant. Standby
mode (after switching off, the date and time are shown in the display) is only available when
the device is connected to the mains.
Page 106

11.4 Language

> Open the [System] sub-menu as described in Section 11.
Use the Tune/Select knob to select the [Language] menu item. Press the Tune/Selectknob
>
to confirm.
> Use the Tune/Select knob to select one of the available languages and confirm the selection by
pressing the Tune/Select knob.

11.5 Factory settings

If you change the location of the device, e.g. when moving house, it is possible that the saved
stations can no longer be received. In this case you can reset the device to Factory Settings to
delete all the saved stations and then launch a new scan.
> Open the [System] sub-menu as described in Section 11.
> Use the Tune/Select knob to select the [Factory setting] menu item. Press the Tune/
Selectknob to confirm.
> Use the Tune/Select knob to reset the factory settings by selecting the [Yes] entry and press
the Tune/Select knob.
DE
EN
Page 107