General Device Functionality; Switching On The Device; Switching Off The Device - Nordmende Transita 30 User Manual

5.4 General device functionality

5.4.1 Switching on the device

> To ensure good DAB+/FM reception, please extend the antenna fully. To do so, please refer
to Section 5.3.2.
> First prepare the Transita 30 for operation as described in Sections 5.3.1 and 5.3.4.
Push the Standby button (4) on the top of the device to switch the Transita 30 on.
>
After switching on for the first time, you must first specify the [Language]. Use the Tune/
Select knob to select one of the available languages and confirm the selection by pressing
the Tune/Select knob. The device then automatically performs a complete scan in DAB
mode. While scanning, the display information shows the progress as well as the number of
digital radio stations detected. After completing the station scan, the first DAB+ channel is
played.
Page 80

5.4.2 Switching off the device

With mains operation:
By briefly pressing the Standby button you can switch the device to standby mode.
>
[Standby] appears briefly on the display. The date and time are shown on the display. The
display brightness in standby mode can be adjusted by following the instructions in
9.2.
With battery operation:
In battery mode, the unit is always switched off by pressing the Standby button. [Power
>
off] appears briefly in the display. In this case, there is no date and time display.
Standby mode and the alarm function are not available in battery operation mode.
Section
DE
EN
Page 81