ADTRAN Total Access 372E Installation And Maintenance Manual page 13

NOTE
• The main feed is optical and therefore not classified as any type of port as
defined in Appendix B of GR-1089-CORE Issue 5.
• The Total Access 372 SBU ONT Chassis frame ground terminal must be
connected to an earth ground to ensure the SBU ONT is properly
grounded.
• Power supply input and output conductors of equipment which are
outside of the building, are intended to be less that 100 feet (30.5 meters)
and have adequate clearance from power and lightning conductors in
accordance with NEC 725 and 800. Final acceptance of the Listed
equipment installation will ultimately be up to the local Authority Having
Jurisdiction (AHJ).
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause
Changes or modifications not expressly approved by ADTRAN could void the user's
authority to operate this equipment.
This product is designed to meet the following environmental classes:
• ETSI EN 300 019-1-1 "Classification of environmental conditions; Storage", Class 1.2
• ETSI EN 300 019-1-2 "Classification of environmental conditions, Transportation", Class
• ETSI EN 300 019-1-4 "Classification of environmental conditions, Stationary use at non-
The equipment is designed to function without degradation during exposure to all test sever-
ities per Class 4.2H of ETSI EN 300 019-1-4.
This product complies with ETSI EN 300 386 "Electromagnetic compatibility and Radio
spectrum Matters (ERM); Telecommunication network equipment; Electromagnetic Compati-
bility (EMC) requirements."
This product meets the EU RoHS Directive 2002/95/EC and/or applicable exemptions. Refer
to www.adtran.com
61287723G1-5B
undesired operation.
2.3
weatherprotected locations", Class 4.2H
for further information on RoHS/WEEE.
Safety and Regulatory Compliance
5