Total Access 372 Active Ethernet Small Business Unit ONT Installation and Maintenance Guide
ODN Interface Troubleshooting
The successful use of the ODN interface connection relies on several factors being within
tolerance. The components must:
• Be clean and dry (refer to Cleaning and Inspection of Components below).
• Have mechanically tight connections.
• Contain the proper optical signal levels. Refer to
The ODN interface within the SBU ONT at the customer premises consists of the elements
depicted in
Cleaning and Inspection of Components
Because the physical size of the transmission core of the optical fiber is typically only 9
microns in size, debris such as a single particle of dust or smoke or strand of hair can impair
the path enough to cause transmission problems. This section provides information and
procedures for the following:
•
•
•
Cleaning Suggestions
Following is a list of suggestions for cleaning connectors, ferrules, and bulkheads:
• Always maintain dust caps and dust plugs installed when connectors or adapters are not
• Avoid allowing unmated connectors to touch surrounding unrelated surfaces and do not
• Use a fiberscope or videoscope to verify proper cleaning of connectors prior to mating
• Use an appropriate quality fabric type cleaner and pure alcohol (reagent grade, 99.5%
36
Figure
17.
Figure 17. ODN Fiber Connection
"Cleaning Suggestions"
"Cleaning the Connectors"
"Signal Level Verification"
mated. Store spare dust caps in a zip-lock bag when not in use.
touch a connector or bulkhead ferrule for any reason other than while performing the
cleaning process.
connecting components together.
pure) when cleaning the endface of connectors. The alcohol can be applied with either
laboratory grade lint-free tissues or with pre-moistened optical grade wipes.
(see below)
on page 37
on page 37
"Signal Level Verification"
on page 37.
61287723G1-5B