ADTRAN Total Access 372E Installation And Maintenance Manual page 12

Total Access 372 Active Ethernet Small Business Unit ONT Installation and Maintenance Guide
!
CAUTION
Electrostatic Discharge (ESD) can damage electronic components. When
handling modules, wear an antistatic discharge wrist strap to prevent
damage to electronic components. Place modules in antistatic packing
material when transporting or storing. When working on modules, always
place them on an approved antistatic mat that is electrically grounded.
C
CAUTION
The optical installation is intended to be installed by trained service
personnel only. This is a 'Class 1 Laser Product'.
!
CAUTION
• For continued compliance with applicable Laser Safety Standards, only
approved 'Class 1 Laser Product' modules from Adtran's approved vendor
list (located on the ADTRAN website, www.adtran.com) should be
installed in the product.
• The Total Access 372 is a Class 1 Laser Module and complies with the Laser
Safety requirements of FDA 21 CFR 1040.10 and 1040.11, and EN60825-1
and -2.
• The Total Access 372 is NRTL Listed to the applicable UL safety standards.
• The Total Access 372 is designed to be deployed in GR-3108-CORE
environmental class 4 as defined in GR-3108-CORE issue 2.
• The Total Access 372 is intended for deployment where the NEC applies
(for example, Customer Premises) and is intended to be installed by trained
service personnel.
• The Total Access 372 is to be serviced by Qualified Service personnel only.
• This product has been evaluated to international safety standards EN
60950-1, AS/NZS 60950.1, and IEC 60950-1. This product meets the
requirements for CE marking under the EMC Directive and Low Voltage
Directive. Standards used to demonstrate Compliance are EN 300 386 and
EN 60950.
4
C A U T I O N C A U T I O N !
SUBJECT TO ELECTROSTATIC DAMAGE
OR DECREASE IN RELIABILITY.
HANDLING PRECAUTIONS REQUIRED.
61287723G1-5B