Optitap Connections; Figure 15. Optitap Connection - ADTRAN Total Access 372E Installation And Maintenance Manual

Total Access 372 Active Ethernet Small Business Unit ONT Installation and Maintenance Guide

OptiTap Connections

To install the OptiTap connection, refer to
1. Unscrew the cover w/lanyard on the bottom of the OptiTap connector. Retain cover.
2. Connect the Fiber Optics Cable (Yellow) to the OptiTap Fiber-In connector.
3. Connect the other end to the SFP connector on the bottom of the Electronics Module.
4. Provide a service loop if necessary.
!
CAUTION
Use caution when routing the fiber optics cable. Avoid severe bending and
routing over sharp edges.
Once the installation is completed, refer to the LEDs (see
Panel to determine operational status.
30
Electronics
Module
Splice Tray
Fiber Optics
Cable
(Yellow)
OptiTap
Fiber-In

Figure 15. OptiTap Connection

Figure 15, and complete the following steps:
TOTAL ACCESS 373E
1287723G1
TELEPHONE TROUBLESHOOTING:
1. Identify the bad line (POTS 1-8).
2. Plug any working phone into
the appropriate jack.
If the telephone works, the unit
is functioning normally.
If the telephone does not work,
contact your service provider.
3. Remove the telephone from the
POTS jack.
Note: All cables removed
for clarity purposes.
Table 9 on page 32) on the Front
61287723G1-5B