Required Tools; Necessary Supplies - ADTRAN Total Access 372E Installation And Maintenance Manual

Required Tools

Standard technician tools are used for a SBU ONT installation (for example, drill, drill bits,
side cutters, screwdrivers, nut drivers, hex wrenches, wire strippers, etc.).
Specifically, the following tools are required for the installation of the SBU ONT:
• Carpenter's level
• 3/32" screw driver
• 5/32" hex tamper-proof bit
• 216-Type can wrench
• Fiber splicing tools
• Eight RJ-11 connectors for POTS testing (used in conjunction with each Pivot connection)
• Two RJ-45 connectors for Ethernet connections
• Four RJ-45 connectors for DS1 connections
• A telephony/data communication test set
• Power meter preferably with wave length filtering
• Fiberscope or videoscope
• Optical Time Domain Reflector meter calibrated for 1310 and 1490 nm output
• Composite fiber cable for non-connectorized installation
• SBU ONT mounting hardware
• Silicone sealant (and application material, i.e., cotton swabs)
• Bonding clamp for grounding and securing the composite cable on non-connectorized
• One each, 60" Hi-cap riser pipe (for composite cable installation)
• Tie wraps
• TexWipe
• TexWipe
Included with the SBU ONT packaging are fiber cable management and strain relief, a fiber
connector, and electronics/optics. For data and video over IP, the connection to the SBU is
through the RJ-45 Ethernet connectors. For POTS, the connection is made using pivot
connectors.

Necessary Supplies

Make sure you have access to the following supplies:
• Appropriate surface anchors for mounting the SBU ONT (each anchor rated to 18 lbs or
• Assorted tie wraps for securing cabling and wiring
61287723G1-5B
installations
TM
Alco pad for fiber cleaning
TM
cloth for fiber cleaning
8.2 kg minimum)
Installation
13