Mounting The Enclosure; Figure 5. Enclosure Mounting Holes - ADTRAN Total Access 372E Installation And Maintenance Manual

Total Access 372 Active Ethernet Small Business Unit ONT Installation and Maintenance Guide

Mounting the Enclosure

Use a maximum of a #10 screw to fit properly in the diameter of the mounting holes (see
Figure
opening the door. Complete the following steps to mount the enclosure:
1. Using the enclosure as a template and a carpenter's level, mark the locations for the three
2. Pre-drill the marked locations and install fasteners or anchors appropriate to the
3. Mount the SBU ONT to the side of the subscriber premise.
16
5). Make sure to leave a minimum clearance of 2 inches (5.1 cm) from the hinges for
mounting holes on the mounting surface. (For an indoor mount, prepare the mounting
surface by attaching a 3/4 inch plywood board to the wall studs. This provides long-term
stability for the SBU ONT.)
mounting surface and the weight of the SBU ONT (each anchor rated to 18 pounds, or 8.2
kg minimum).
Surface Mounting
Hole
Surface
Mounting
Hole

Figure 5. Enclosure Mounting Holes

Surface
Mounting
Hole
61287723G1-5B