Using The Remote; Pod Call Button; Return The Components To The Base Station For Nightly Recharging - Lightspeed Flexcat Daily Operation Instructions

Using the remote:

Function Command
1
Whole Class Press center
Instruction button
4 2
Pod Selection Press #1-6
3
6
5
Small Group Press MUTE
Monitoring
Mute Vol
Vol
Student Group Press #1-6, then
Sharing center button
(rapid press)
Disconnect Press activated
pod # or center
button again
Teacher earbud Press Vol UP/
volume DOWN arrows.
1.

Pod call button:

• Each of the pods are equipped with a call button students can press when they need
assistance.
• When the button is pressed, a tone sounds in the teacher earbud.
• The corresponding pod # will blink on the remote, alerting the teacher which group needs
assistance.
• The light will continue to blink until the teacher selects that pod.
• To clear multiple blinking lights: press center button twice (connect and disconnect from
whole class mode).
2.

Return the components to the base station for nightly recharging:

• For convenience, we recommend leaving the pods powered on. They are designed to
charge normally in the ON position.
• Place all components in their respective charging slots:
– Pods: insert with charging contacts facing down.
– Flexmike(s): use corresponding mic 1 or 2 center charging slot.
– Remote(s): use corresponding mic 1 or 2 outside charging slot.
•
Charging lights will turn on - red = charging; green = fully charged.
• The units will fully charge overnight.
NOTE: the blue link lights on the Flexmike(s) and pods will stay on to indicate the microphone
number (1 or 2) and that they are ready for operation.
LI GHT S PE ED TE CHN OLOGIE S
WWW. LI GHTSPEE D-TEK. CO M / TOL L FREE: 8 00.73 2. 8999 / PH ONE: 503. 684.5538
Description
Activates Redcat Access speaker to distribute teachers voice
to the entire class.
Connect to each individual student group pod. The pod #
button will light and a tone will sound in the earbud when
connected (1-2 seconds).
Move from pod to pod to monitor (listen only) student
groups. The MUTE button will light green and the pod
button will light red to indicate the teacher's microphone is
muted. To unmute, simply press the MUTE button again.
Allows one student group to address the whole class. Both
the center and pod # buttons will light and a tone will sound
in the earbud when connected (1-2 seconds).
Disconnects the transmission and turns any audio off. The
pod # button or center button will go dark.
Turns the volume to the teacher's earbud up or down. There
is an audible tone in the ear when pressing.
DAILY OPERATION
QS0477US01-2